Energy harvesting system integrates easily into clothing

September 22, 2020 //By Nick Flaherty
Researchers at KAIST in Korea have developed a piezoelectric energy harvesting system that can be easily and reliably added to clothing to power wearable electronics
Researchers at KAIST in Korea have developed a piezoelectric energy harvesting system that can be easily and reliably added to clothing to power wearable electronics

Researchers at KAIST in Korea have developed a highly flexible but sturdy wearable piezoelectric energy harvesting system using a simple and easy fabrication process of hot pressing and tape casting.

This energy harvesting system has a record interfacial adhesion strength, bringing embedded wearable electronics a step closer.

A research team led by Professor Seungbum Hong said that the novelty of this result lies in its simplicity, applicability, durability, and its new characterization of wearable electronic devices. A patent for the process has been applied for in Korea.

"This study could enable the commercialization of highly durable wearable devices based on the analysis of their interfacial adhesion strength. Our study lays a new foundation for the manufacturing process and analysis of other devices using fabrics and polymers. We look forward to fabric-based wearable electronics hitting the market very soon," said Hong.

The fabric has a heterostructure of a ferroelectric polymer, poly(vinylidene fluoride-co-trifluoroethylene) [P(VDF-TrFE)] and two conductive fabrics. Simulation and experimental analysis showed fully bendable, compact and concave interfaces and a high piezoelectric coefficient of −32.0 pC/N.

The record high interfacial adhesion strength of 22 N/cm between the P(VDF-TrFE) layer and fabric layers has been measured by surface and interfacial cutting analysis system (SAICAS) for the first time in the field of fabric-based wearable piezoelectric electronics.

For this process, the research team used a hot pressing and tape casting procedure to connect the fabric structures of polyester and a polymer film. Hot pressing has usually been used when making batteries and fuel cells due to its high adhesiveness. Above all, the process takes only two to three minutes. The newly developed fabrication process will enable the direct application of a device into general garments using hot pressing just as graphic patches can be attached to garments using a heat press.

In particular, when the polymer film is hot pressed onto a fabric below its crystallization temperature, it transforms into an amorphous state. In this state, it compactly attaches to the


Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.