Resonant controller with PFC for power supply and lighting drivers
Main target applications for the ICL5102 are LED drivers for professional and industrial lighting, and street lighting. The controller IC can also be used for offline AC-DC power supplies and LCD TVs.
The ICL5102 integrates the PFC and half-bridge controllers in a single DSO-16 package. It supports universal input voltages ranging from 70 V AC to 325 V AC, and has a comparable wide output range. All parameters are set by resistors.
It supports fast startup under 500 ms at less than 100 μA and the PFC is greater than 99 percent and Total Harmonic Distortion (THD) is less than 3.5 percent. The controller has up to 94 percent efficiency by using a resonant topology and the active burst mode for low standby consumes less than 300 mW. An enable/disable function supports dimming.
The PFC controller features brownout detection, adjustable THD for light load operation, and high power factor correction. Due to the high accuracy of BUS voltage sensing, only four PINs are required for PFC action. The resonant HB controller has a fully integrated 650 V high-side driver using an internal coreless transformer with self-adaptive dead time ranging between 250 ns and 750 ns, and an operating frequency up to 500 kHz. It can detect overload, short circuit, BUS, HB or output under and over voltage as well as over temperature. An integrated capacitive mode regulator prevents operation in capacitive mode. All protection features use AUTO restart (No Latch).
Engineering samples and a reference design, REF-ICL5102-U130W-CC, are available now. Full production is ramped up and shipment will start in Q2 2018.
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
