Interface module for strain gauge amplifier load cell conditioners
An important feature of the Bridge Completion Module is that it is easily installed. It simply screws into the existing load cell connector on the SGA amplifier module. It also has on-board screw terminal connections that accept a wide range of bridge completion resistors, enabling on-site installation without soldering equipment.
The company’s strain gauge amplifier is a high performance signal conditioner for single or multiple strain gauge bridge sensors such as load, force, pressure and torque. The SGA offers a wide bandwidth and a wide input signal range. The device can be powered from AC or DC supplies providing excitation for up to 4 x 350 ohm strain gauge bridges.
The quarter bridge strain gauge circuit, together with its completion resistor can be wired for compression or tension (stretching) giving a positive output and half bridge strain gauge devices are simply connected to the BCM module via the screw terminals, with no additional components required.
The Bridge Completion Module has high stability resistors (5ppm/°C) fitted for the ‘fixed’ arms of the bridge, and screw terminals are provided for a ‘Shunt Calibration’ shunt resistor to be fitted, to periodically check the integrity of the strain gauge(s), wiring and calibration. A ‘Remote Shunt Calibration’ can be performed by energising a miniature 24V relay fitted to the BCM. Multiple SGAs in an installation can be shunt calibrated simultaneously.
Visit Mantracourt at www.mantracourt.co.uk