MENU

CEA-Leti and Edwards join forces on energy-efficient fabs

Technology News |
By admin

The system was successfully tested for reliability and energy savings on two tools at CEA-Leti and showed a 75 percent reduction in fuel and water use when the abatement system was in idle mode. Based on the results, Edwards will develop and launch a new energy-saving system for fab operators this year.

The project was begun after Leti engineers, as part of their involvement in sustainability and green microelectronics, discovered that vacuum pumps and abatement systems in their subfab consumed the same amount of energy whether or not the process tools were working, because there is generally no direct communication on the tool status with the subfab.

Leti and Edwards, for whom energy efficiency is a key research topic, launched a one- year co-development program in January 2010 to develop a controller system capable of monitoring indirectly the status of the process tool and signaling for the process pumps and abatement system to go into idle mode.

Edwards’ latest-generation pumps and abatement systems are specifically designed to maximize energy savings by allowing process tools or factory automation systems to automatically switch among various low-energy (Green Mode) or high-performance operating modes to match the real-time requirements of the process.

The co-developed system at Leti uses information from both the load lock and process pumps to determine the process status of the tool and thus can provide a signal for standby control to the subfab abatement equipment with configurable thresholds and wait times.

Visit CEA-Leti at www.leti.fr

Visit Edwards at www.edwardsvacuum.com


Share:

Linked Articles
eeNews Power
10s