Wake up primary-side regulated flyback

April 28, 2016 // By Michael O’Loughlin
Schematic of an offline primary-side regulated flyback converter
Michael O’Loughlin, Senior Applications Engineer, Texas Instruments discusses a technique for PSR flyback converters that speeds up the transient response and reduces the amount of output capacitance that the design requires for good transient response.

Primary-side regulated (PSR) flyback converters (Figure 1) have been a popular choice for reducing standby power in low-power adapters and bias supplies. These controllers have been able to achieve less than 5 mW of no-load standby power by using a frequency modulation (FM), current amplitude modulation (AM) scheme to reduce switching losses and standby power.

A significant problem with this control scheme is that the converter has slow transient response at light loads, which the designer has to overcome by adding more output capacitance to meet hold-up requirements.  The technique described will enable PSR flyback designers to design for higher power densities and reduce overall design cost.

Figure 1: Schematic of an offline primary-side regulated flyback converter.

Before discussing how to speed up the PSR flyback converter, let us review the PSR flyback control methodology. The PSR control scheme senses at the VS pin the scaled output voltage (V OUT) through the transformer’s auxiliary-turns ratio (N A/NS). This technique eliminates the need for TL431 opto-isolator feedback circuitry. Removing this circuitry reduces your design’s standby power by roughly 2.5 to 5 mW. Equation 1 describes the mathematical relationship between VS and V OUT.



PSR controllers use a combination of valley switching, FM and primary peak current (I PP) amplitude modulation to control the duty cycle (D) of a quasi-resonant / discontinuous flyback converter. Equation 2 is a simplified equation describing the D of this offline power converter. Variable t ON is the switch (Q1) on time. Variable tC is the time when the output diode (D G) is conducting and the transformer (T1) is delivering energy to the output of the converter. Variable t D is the dead time adjusted by the PSR controller to then adjust the duty cycle.



The traditional PSR controller feedback circuitry will only sample the voltage on the auxiliary winding (V A) when

Design category: 

Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.